Service Plan D - $480

ANNUAL SYSTEM TUNE-UP

(Scheduled outside of heating season unless otherwise approved)

Just like changing the oil in your car – your furnace should be tuned up annually.  This is good for you and the environment as it helps reduce the amount of fuel you use which will reduce your energy bills.

  1. Test and regulate all burner and safety controls
  2. Clean or replace fuel oil strainers
  3. Replace nozzle
  4. Check and adjust ignition system
  5. Vacuum furnace/boiler
  6. Check and lubricate motors
  7. Replace oil filter cartridge
  8. Inspect combustion chamber
  9. Adjust heating unit to maximum efficiency

ULTRASONIC TANK TESTING

This provides peace of mind coverage for your oil storage tank.

Qualifying tanks receive a $1000 tank replacement payment to help cover the cost of a replacement.

EPA Approved Testing Technology.  Ultrasonic equipment detect the level of corrosion inside oil tanks.

Inspection of common tank components such as legs, seams, fill and vent pipes, oil lines and vent whistle.

Efficiency Combustion Test

EMERGENCY SERVICE

We offer 24-hour, 7 days a week Emergency Service. Your family can rest easy with this valuable service

PARTS & LABOR COVERAGE

Through this service agreement we will cover all parts and labor as described below for one full year.  We will also provide a 24 hour emergency burner service under this agreement.  Please note:  Hot water is not an emergency and will be scheduled during business hours: weekdays 8am-5pm, Saturday 8am-12pm (during the heating season).The annual cleaning is covered and will be scheduled during the non-heating season unless otherwise needed.

**Stack relays are not covered by the service agreement and must be replaced with a Primary Control prior to enrollment.

Controls & Electrical

Burner Parts

Water Parts

Barometric Damper
Gauge Glass
High/Low Limit Control
Multi-Aquastat
Multi-Aquastat Relay
Powerheads (1) head only
Pressure Limit Control
Thermostat (Heat Only)
Transformer (24v)
Zone Valve Head (1)
Blower Fan Belt
Circulator Relay Hot Air Parts
Blower Bearings
Blower Fan
Fan Control
Blower Motor Belt Drive
Direct Drive Blower MotorBlower Pulley
Burner Cables
Burner Switch
Cad Cell Lead
Cad Cell Relay
Cadmium Cell
Delayed Oil Valve
Electrode
Emergency Switch
Fuel Oil Filter
Jet Line
Oil Burner Air Cone
Oil Burner Coupling
Oil Burner Transformer
Oil Burner Fan
Oil Burner Motor
Oil Burner Nozzle
Oil Burner Pump
Nozzle Assembly
Primary Control
Spin-on-Oil Filter
#30 Expansion Tank
007 Circulator
Air Scoop
Boiler Drain
Circulator Drain
Circulator Gaskets
Feed & Back Flow
Feed Valve
Highvent
Honeywell motorized one Valve
Hot Water Heater Aquastats
McDonald Miller 68 LW/Co Head Assembly
Purging of Zones up to 2 Hours (LW/CO ProbeType)
Radiator Vent
Steam Return Vent
Taco Zone Valve Body

**Additional zones may be covered for $35 each

**This agreement also covers water heat burners for an additional charge of $110

Boilers, piping, furnaces, air ducts, registers, radiator valves and other equipment not specified above are not included in this agreement and are subject to material and labor charges.